how to tie a tie

Tying a tie can be a bit tricky at first, but with practice, you’ll master it in no time! Here’s a step-by-step guide to tying a classic Windsor knot, which is versatile and suitable for most occasions:

  1. Drape the Tie: Start with the tie around your neck, with the wide end hanging about 12 inches (30 cm) lower than the narrow end. The wide end should be on your right and the narrow end on your left.
  2. Cross Over: Cross the wide end over the narrow end, forming an X just below your chin.
  3. Loop Around: Bring the wide end under the narrow end and pull it up through the loop around your neck.
  4. Across and Through: Pull the wide end across the front of the knot to your right.
  5. Up and Through: Pull the wide end up through the loop around your neck, from underneath.
  6. Adjust and Tighten: Adjust the knot by holding the narrow end and sliding the knot up towards your collar. Tighten the knot by gently pulling on the wide end.
  7. Finish: Tuck the narrow end behind the loop of the knot and adjust the length as needed.

Leave a Comment

Your email address will not be published. Required fields are marked *

1 + nineteen =

Scroll to Top